Hobby machine shop

Post Reply
Jake Parker
Fair Weather Camper
Posts: 20
Joined: Thu Feb 25, 2021 6:07 pm

Hobby machine shop

Post by Jake Parker »

I have a hobby machine shop in the backyard.
I have built it over the last 8 years to what it is now.
I have lately used it to do hydraulic cylinder repair for my day job as a tractor mechanic .
I have done a little gun smithing as well.
So far the coolest job I have been commissioned to do is mill a plate of steel from the "Battle ship Texas" down from 3/4" thick to 1/8" thick.
The piece was about 12 inches square. It had been cut out for a repair job. The BST foundation wanted to leave the show side corroded as is.
I then had a company in Nacadoches water jet out pentagon stars that were to be inlet into the stocks of custom engraved Henry rifle to commemorate the battle ship "Texas"!
"I'd rather have overkill, than be killed" my quote when building anything.
User avatar
BigJesse
Site Admin
Posts: 2598
Joined: Fri May 03, 2013 9:51 pm
Location: Copperas Cove, Tx
Contact:

Re: Hobby machine shop

Post by BigJesse »

Cool. Machining has always piqued my interest. Now more than ever. I have far too many expensive hobbies as is to dive into another one.
2021 - 12 Nights Under The Stars
Personal Best: 17 Nights (2019)

Image
Texas Bushcraft's YouTube, Texas Bushcraft's Facebook
Post Reply